OUTER REAR VIEW MIRROR GLASS REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE OUTER MIRROR LH


    1. B006RKUC02
      B006PCE Protective Tape
      B006N8A Push

      Push the lower part of the mirror surface and tilt it.

    2. Put protective tape as shown in the illustration.

    3. B006RKUC03
      B006PCE Protective Tape
      B006N8A Push

      Push the upper part of the mirror surface and tilt it.

    4. Put protective tape as shown in the illustration.

    5. B006PEFC01
      B006NJK Pull Out
      B006N8A Remove in this Direction

      Using moulding remover D, detach the claw of the outer mirror LH as shown in the illustration.

    6. Pull out the upper part of the mirror surface and tilt it.

      Tech Tips

      The claw will be attached again if the mirror surface is pull out with excessive force.

    7. B006RLWC01
      B006NJK Pull Out
      B006N8A Remove in this Direction

      Using moulding remover D, detach the claw of the outer mirror LH as shown in the illustration.

    8. w/o Mirror Heater:


      1. Remove the outer mirror LH.

    9. w/ Mirror Heater:


      1. B006RJI

        Disconnect the connector and remove the outer mirror LH.

    10. w/ Blind Spot Monitor System:


      1. B006P6L

        Detach the clamp.

      2. Disconnect the connector and remove the outer mirror LH.