FRONT WIPER MOTOR(for LHD) REMOVAL

PROCEDURE


  1. REMOVE WINDSHIELD WIPER ARM COVER


    1. A01IG6NC01
      B006PCE Protective Tape

      Using a screwdriver, detach the claw and remove the windshield wiper arm cover.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for both windshield wiper arm covers.

  2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    1. A01IL3A

      Remove the nut and the front wiper arm and blade assembly LH.

  3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    1. A01IJIP

      Remove the nut and the front wiper arm and blade assembly RH.

  4. REMOVE COWL WATER EXTRACT SHIELD LH


    1. A01IHGOC01
      B006Q1Z Place Hands Here
      B006N8A Lift Up

      Lift up the edge of the cowl water extract shield LH as shown in the illustration and detach the claw.

    2. A01IEZXC01
      B006N8A Remove in this Direction

      Pull the cowl water extract shield LH as shown in the illustration to detach the guide and remove the cowl water extract shield LH.

  5. REMOVE COWL WATER EXTRACT SHIELD RH

    Tech Tips

    Use the same procedure for the LH side.

  6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    1. A01IHP1

      Remove the 2 clips.

    2. A01IESG

      Detach the claw.

    3. A01IK9KC01
      B006N8A Remove in this Direction

      Pull the cowl top ventilator louver sub-assembly as shown in the illustration to detach the guide and remove the cowl top ventilator louver sub-assembly.

  7. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Note

    Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.


    1. A01IK0AC01
      *1 Motor Grommet
      B006QOD Bolt
      B006LKF Connector
      B006N8A Remove in this Direction

      Disconnect the connector.

    2. Remove the 3 bolts.

    3. Detach the motor grommet as shown in the illustration and remove the windshield wiper motor and link assembly.

  8. REMOVE FRONT WIPER CRANK SUB-ASSEMBLY


    1. A01IJO3C01
      B006PCE Protective Tape
      B006N8A Remove in this Direction

      Using a screwdriver, disconnect the No. 1 windshield wiper link rod from the front wiper crank sub-assembly crank arm pivot.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A01IIR1C01
      B006PCE Protective Tape

      Using a screwdriver, hold the windshield wiper motor crank as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. Remove the nut and front wiper crank sub-assembly.

  9. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    1. A01IGS4

      Detach the clamp.

    2. Remove the 3 bolts and windshield wiper motor assembly from the windshield wiper link assembly.