BACK DOOR WEATHERSTRIP INSTALLATION

PROCEDURE


  1. INSTALL BACK DOOR WEATHERSTRIP


    1. B006O0DC02
      *a Paint Mark
      *b Mark Position
      *c Weatherstrip Joint

      Remove any non-drying sealer on the body with non-residue solvent.

    2. Align the paint marks with the positions on the body flange and install a new back door weatherstrip.

      Note


      • Always align the paint mark when installing the part. If the paint mark position is out of place, coolant leaks may occur.

      • After the installation, check that the corners are properly installed.

      Tech Tips

      To easily install the weatherstrip, first install the area with the paint mark as shown in the illustration. Then install the part toward the corners and push any excess length into the corners.

  2. CONNECT POWER BACK DOOR ROD (w/ Power Back Door)

    Click here

  3. INSTALL BACK DOOR SIDE GARNISH LH (w/ Power Back Door)

    Click here

  4. INSTALL BACK DOOR SERVICE HOLE COVER LH (w/ Power Back Door)

    Click here

  5. INSTALL CENTER BACK DOOR GARNISH (w/ Power Back Door)

    Click here