POWER SLIDE DOOR SYSTEM Assist Function does not Operate (Normal Operation via Door Control Switch) (LH Door)

DESCRIPTION

The slide door motor unit LH (slide door ECU LH) receives signals from the inside handle or outside handle in the slide door handle assembly LH and performs power slide door open or close operations.

WIRING DIAGRAM

B006QWPE05

PROCEDURE


  1. READ VALUE USING GTS


    1. Read the Data List according to the display on the GTS.

      Click here


      Body Electrical > Rear Left Door > Data List
      Tester Display Measurement Item Normal Condition Reference Value Diagnostic Note
      Handle Switch1 Inside handle switch (close switch) signal ON or OFF

      ON: Slide door inside handle close operation performed (inside handle switch [close switch] on)

      OFF: Slide door inside handle operation not performed or open operation performed (inside handle switch [close switch] off)

      		 -
      Handle Switch2 Inside handle switch (open switch) signal ON or OFF

      ON: Slide door inside handle open operation performed (inside handle switch [open switch] on)

      OFF: Slide door inside handle operation not performed or close operation performed (inside handle switch [open switch] off)

      		 -
      Outside PSD Switch Status of outside handle (outside handle switch) ON or OFF

      ON: Outside handle operated (outside handle switch on)

      OFF: Outside handle not operated (outside handle switch off)

      		 -

      Body Electrical > Rear Left Door > Data List
      Tester Display
      Handle Switch1
      Handle Switch2
      Outside PSD Switch
      OK
      On the GTS screen, ON or OFF is displayed accordingly.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE SLIDE DOOR MOTOR UNIT LH Click here

    NG

  2. INSPECT SLIDE DOOR HANDLE ASSEMBLY LH


    1. Remove the slide door handle assembly LH.

      Click here

    2. Inspect the slide door handle assembly LH.

      Click here

      Result
      Proceed to
      OK
      NG

    NG

    REPLACE SLIDE DOOR HANDLE ASSEMBLY LH Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (SLIDE DOOR HANDLE ASSEMBLY LH - SLIDE DOOR MOTOR UNIT LH AND BODY GROUND)


    1. Disconnect the J21 slide door handle assembly LH connector.

    2. Disconnect the J24 and J25 slide door motor unit LH (slide door ECU LH) connectors.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J21-3 (DS2) - J25-11 (DS2) Always Below 1 Ω
      J21-1 (E) - J24-9 (DSG) Always Below 1 Ω
      J21-4 (DS1) - J25-13 (DS1) Always Below 1 Ω
      J21-2 (GND) - Body ground Always Below 1 Ω
      J21-3 (DS2) or J25-11 (DS2) - Body ground Always 10 kΩ or higher
      J21-1 (E) or J24-9 (DSG) - Body ground Always 10 kΩ or higher
      J21-4 (DS1) or J25-13 (DS1) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE SLIDE DOOR MOTOR UNIT LH Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR