POWER SLIDE DOOR SYSTEM CUSTOMIZE PARAMETERS


  1. CUSTOMIZE POWER SLIDE DOOR SYSTEM

    Tech Tips

    The following items can be customized.

    Note


    • When the customer requests a change in a function, first make sure that the function(s) can be customized.

    • Be sure to make notes of the current settings before customizing.

    • When troubleshooting a function, first make sure that the function is set to the default setting.


    1. Customizing with the GTS


      1. Connect the GTS to the DLC3.

      2. Turn the engine switch on (IG).

      3. Turn the GTS on.

      4. Enter the following menus: Customize Setting / PSD & PBD operation.

      5. Select the setting by referring to the table below.


        PSD & PBD operation
        Tester Display Description Default Setting ECU
        PSD SW Operation (RR) Function to operate door control switch assembly 0.8s 0:ON,1:0.8s Slide Door Motor Unit RH (Slide Door ECU RH)
        PSD SW Operation (RL) Function to operate door control switch assembly 0.8s 0:ON,1:0.8s Slide Door Motor Unit LH (Slide Door ECU LH)
        Wireless PSD SW Operation(RR) Function to operate electrical key transmitter sub-assembly long 0000:OFF,0001:1Oper,0010:2Oper,0011:long,1010:2/OM,1011:L/OM Slide Door Motor Unit RH (Slide Door ECU RH)
        Wireless PSD SW Operation(RL) Function to operate electrical key transmitter sub-assembly long 0000:OFF,0001:1Oper,0010:2Oper,0011:long,1010:2/OM,1011:L/OM Slide Door Motor Unit LH (Slide Door ECU LH)
        One Touch Open/Close SW Operation Setting (RL) Function to operate one-touch switch Short Push (0.3s) 00:Short Push (0.3s),01:Middle Push (0.5s),10:Long Push (0.8s),11:OFF Slide Door Motor Unit LH (Slide Door ECU LH)
        One Touch Open/Close SW Operation Setting (RR) Function to operate one-touch switch Short Push (0.3s) 00:Short Push (0.3s),01:Middle Push (0.5s),10:Long Push (0.8s),11:OFF Slide Door Motor Unit RH (Slide Door ECU RH)

    2. Customizing with the combination meter assembly


      1. Turn the engine switch on (IG).

      2. Enter the following menus: Settings.

      3. Select the setting by referring to the table below.

        Note

        Be sure to record the current value before customizing.

        Settings
        Combination Meter Assembly Display Description Default Setting ECU
        Tone Settings for the tone of the buzzer that sounds at the start of, and during, power slide door operation Buzzer A Buzzer A, Buzzer B or Buzzer C Combination meter assembly
        Volume Settings for the volume of the buzzer that sounds at the start of, and during, power slide door operation Loud OFF, Quiet or Loud Combination meter assembly