POWER WINDOW REGULATOR MOTOR(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

   
   

   1. 

      Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly LH.

   2. Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 "TORX" screws.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      A new power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

   Click here

3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

   Click here

4. INSTALL REAR DOOR GLASS RUN LH

   Click here

5. INSTALL NO. 2 SLIDE DOOR SERVICE HOLE COVER

   Click here

6. INSTALL SLIDE DOOR PANEL COVER SUB-ASSEMBLY LH

   Click here

7. INSTALL REAR DOOR LOCKING CONTROL LINK SUB-ASSEMBLY LH

   Click here

8. INSTALL SLIDE DOOR HANDLE ASSEMBLY LH

   Click here

9. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP WITH GARNISH

   Click here

10. INSTALL REAR DOOR FRONT WINDOW GUIDE LH

    Click here

11. INSTALL SLIDE DOOR WINDOW GARNISH LH

    Click here

12. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

13. INSTALL NO. 3 SLIDE DOOR WEATHERSTRIP LH

    Click here

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

15. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

16. CHECK POWER WINDOW

    Click here