POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the power window regulator motor removal/installation are shown below.

Necessary Procedures After Parts Removed / Installed / Replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative (-) battery terminal	Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here
Rear door window regulator assembly Power window regulator motor assembly Rear door glass sub-assembly Rear door glass run	Initialize Power Window Control System	Auto up and down function Jam protection function Remote control function Key-linked function Wireless transmitter-linked function Key-off operation function Catch protection function Window open warning function	Click here

Tech Tips

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.
When removing the rear door glass sub-assembly LH, move the rear door glass sub-assembly LH to the lowest position before disconnecting the negative (-) battery terminal.

PROCEDURE

PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE NO. 3 SLIDE DOOR WEATHERSTRIP LH

Click here
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Click here
REMOVE SLIDE DOOR WINDOW GARNISH LH

Click here
REMOVE REAR DOOR FRONT WINDOW GUIDE LH

Click here
REMOVE REAR DOOR INNER GLASS WEATHERSTRIP WITH GARNISH

Click here
REMOVE SLIDE DOOR HANDLE ASSEMBLY LH

Click here
REMOVE REAR DOOR LOCKING CONTROL LINK SUB-ASSEMBLY LH

Click here
REMOVE SLIDE DOOR PANEL COVER SUB-ASSEMBLY LH

Click here
REMOVE NO. 2 SLIDE DOOR SERVICE HOLE COVER

Click here
REMOVE REAR DOOR GLASS RUN LH

Click here
REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Click here
REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Click here
REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
1. Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws and power window regulator motor assembly LH.
  
  Note
  
  Be careful when removing the "TORX" screws as the motor may fall and become damaged.