POWER WINDOW REGULATOR MOTOR(for Front Door) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

   
   

   1. 

      Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly LH.

   2. Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 "TORX" screws.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      A new power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

   Click here

3. INSTALL FRONT DOOR GLASS RUN LH

   Click here

4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

   Click here

5. INSTALL FRONT DOOR SERVICE HOLE COVER LH

   Click here

6. INSTALL FRONT DOOR REAR BELT SEAL LH

   Click here

7. INSTALL FRONT DOOR FRONT BELT SEAL LH

   Click here

8. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

   Click here

9. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

10. INSTALL FRONT ARMREST ASSEMBLY LH

    Click here

11. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

12. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

13. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

14. INSTALL LOWER DOOR FRAME GARNISH LH

    Click here

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

16. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

17. CHECK POWER WINDOW

    Click here