COMPRESSOR(for 2GR-FKS) INSPECTION

PROCEDURE


  1. INSPECT COOLER COMPRESSOR ASSEMBLY (A/C LOCK SENSOR)


    1. B006POIC04
      *a

      Component without harness connected

      (Cooler Compressor Assembly (A/C Lock Sensor))

      Inspect the cooler compressor assembly (A/C Lock Sensor)


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 (SSR+) - 2 (SSR-) 20 °C (68 °F) 160 to 320 Ω

        If the result is not as specified, there may be a malfunction in the cooler compressor assembly.

  2. INSPECT COOLER COMPRESSOR ASSEMBLY (COMPRESSOR SOLENOID)


    1. B006RBZC23
      *a

      Component without harness connected

      (Cooler Compressor Assembly (Compressor Solenoid))

      Inspect the cooler compressor assembly (Compressor Solenoid)


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 (SOL-) - 2 (SOL+) 25°C (77°F) 10.1 to 11.1 Ω

        If the result is not as specified, there may be a malfunction in the cooler compressor assembly.

  3. INSPECT COMPRESSOR AND MAGNET CLUTCH (MAGNET CLUTCH ASSEMBLY)


    1. B006POIC05
      *a

      Component without harness connected

      (compressor and magnet clutch (Magnet Clutch Assembly))

      Inspect the compressor and magnet clutch (Magnet Clutch Assembly)


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 (MG+) - Body ground 20°C (68°F) 4.94 to 5.34 Ω

        If the result is not as specified, there may be a malfunction in the magnet clutch assembly.

      2. When connector terminal 3 (MG+) is connected to a positive (+) battery terminal, check that the following occurs: 1) the magnet clutch operating sound can be heard, and 2) the magnet clutch hub and rotor lock.


        • If the result is not as specified, there may be a malfunction in the magnet clutch assembly.