PTC HEATER ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the PTC heater assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

PROCEDURE

REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

Click here
REMOVE NO. 4 AIR DUCT SUB-ASSEMBLY

Click here
REMOVE NO. 2 INSTRUMENT PANEL TO FLOOR BRACE SUB-ASSEMBLY

Click here
REMOVE NO. 1 INSTRUMENT PANEL TO FLOOR BRACE SUB-ASSEMBLY

Click here

REMOVE NO. 1 INSTRUMENT PANEL BRACE SUB-ASSEMBLY

	Nut
	Bolt
	Screw

Disconnect each connector and detach each clamp.

Remove the 2 screws, bolt, 2 nuts and No. 1 instrument panel brace sub-assembly.

REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY

Click here
REMOVE QUICK HEATER ASSEMBLY
1. Remove in this Direction
  
  Detach the clamp and disconnect the 2 connectors.
2. Remove the screw and quick heater assembly.