REAR POWER SEAT CONTROL SYSTEM(w/ Memory) INITIALIZATION


  1. SEAT POSITION INITIALIZATION

    Note

    When either of the following operations is performed, clear the seat position memory and register the seat position.


    • When replacing the fold seat control ECU with a new one.

    • When the power supply of the position control ECU assembly is cut while the rear No. 1 seat is operating.

    B006LICC06
    *1 Reclining Switch (Forward) *2 Ottoman Switch (Open)
    *3 SET Switch *4 Rear Power Seat Switch

    1. Clear the seat position memory

      Tech Tips


      • Move the seatback to the foremost position and the ottoman to the highest position before starting the seat position memory clear operation.

      • If the SET switch is pressed but not held on the 5th time, perform the procedure from the step marked *1 again.

      • If the ottoman switch (open) has not been pressed 5 times when 10 seconds have elapsed after the reclining switch (forward) was pressed and held, perform the procedure from the step marked *1 again.

      • If any operations other than the following are performed, perform the procedure from the step marked *1 again.


      1. Press and hold the reclining switch (forward).*1

      2. Press and hold the ottoman switch (open) while the reclining switch (forward) is being pressed.

      3. Press the SET switch 5 times (press and hold the switch on the 5th time) while the reclining switch (forward) and ottoman switch (open) are being pressed.

      4. When 10 seconds have elapsed after the reclining switch (forward) was pressed and held, check that the buzzer sounds for 0.5 seconds and the seat position memory is cleared.

    2. Register the seat position


      1. Press and hold the reclining switch to move the seatback to the foremost or fully reclined position and keep the seatback at the same position until the buzzer sounds for 0.1 seconds.

      2. Press and hold the ottoman switch to move the ottoman to the uppermost or fully stored position, and keep the ottoman at the same position until the buzzer sounds for 0.5 seconds.