REAR AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR AIRBAG SENSOR LH

   
   

   1. Check that the engine switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      
      

      • 

        Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • 

        If this procedure is performed without disconnecting the negative (-) terminal of the battery, the airbag may deploy even if an impact is applied only to the rear airbag sensor LH. Therefore, make sure that the negative (-) terminal of the battery is disconnected before performing this procedure.

   3. Attach the guide and hold the rear airbag sensor LH in place.

   4. Install the bolt.

      Torque:

      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note

      
      

      • If the rear airbag sensor LH has been dropped, replace it with a new one.

      • When installing the rear airbag sensor LH, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Tighten the bolt while holding the rear airbag sensor LH because the rear airbag sensor LH guide is easily damaged.

   5. Before connecting the airbag connector, check that the position of the housing lock is correct as shown in the illustration.

      

      *a	Correct	*b	Incorrect
      *c	CPA	*d	Housing

   6. Connect the airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

      
      

      1. While holding the CPA, be sure to engage the connectors until they are locked and check that the CPA is in its original position (when locking, make sure that a click sound can be heard).

         Note

         Do not push down the upper part of the CPA shown in the illustration when connecting the airbag connector.

         

         *a	CPA	*b	CPA Upper Part
         *c	Connection is Completed	-	-
         	Connect in this Direction	-	-

   7. Check that there is no looseness in the installation parts of the side airbag sensor assembly LH.

2. INSTALL REAR QUARTER TRIM PANEL ASSEMBLY LH

   Click here

3. INSTALL ROPE HOOK ASSEMBLY

   Click here

4. INSTALL NO. 2 LUGGAGE COMPARTMENT TRIM HOOK

   Click here

5. INSTALL REAR DOOR SCUFF PLATE LH

   Click here

6. INSTALL BACK DOOR SCUFF PLATE

   Click here

7. INSTALL UPPER REAR NO. 2 FLOOR BOARD PLATE

   Click here

8. INSTALL UPPER REAR NO. 1 FLOOR BOARD PLATE

   Click here

9. INSTALL REAR NO. 2 FLOOR BOARD ASSEMBLY

   Click here

10. INSTALL REAR NO. 1 FLOOR BOARD ASSEMBLY

    Click here

11. INSTALL UTILITY BOX SUB-ASSEMBLY

    Click here

12. INSTALL REAR NO. 3 FLOOR BOARD ASSEMBLY

    Click here

13. INSTALL DECK SIDE GARNISH LH

    Click here

14. INSTALL DECK SIDE GARNISH RH (for RH Side)

    Click here

15. INSTALL REAR NO. 2 SEAT ASSEMBLY LH

    Click here

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

17. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

18. CHECK SRS WARNING LIGHT

    Click here