FRONT SEAT SIDE AIRBAG ASSEMBLY(for Super Long Slide Seat) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:


  • B006LWS

    Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

  • If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

  • Replace any other damaged parts as necessary.

PROCEDURE


  1. INSTALL FRONT SEAT AIRBAG ASSEMBLY LH


    1. Install the front seat airbag assembly LH with 2 new nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Note


      • The nuts must not be reused.

      • Make sure that the separate type front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.

    2. B006M8KC01
      *a Housing Lock
      *b CPA
      *c CPA Upper Part
      B006N8A Connect in this Direction

      Attach the wire harness clamp.

    3. Before connecting the connector, check that the position of the housing lock is correct as shown in the illustration.

      B006Q9AC01
      *a Correct *b Incorrect
      *c CPA - -

    4. While holding the CPA be sure to engage the connectors until they are locked and check that the CPA is in its original position (when locking, make sure that a click sound can be heard).

      Note


      • Be careful not to damage the side airbag connector or wire harness.


      • When connecting the connector, make sure to push it straight in.


      • Do not hold any parts other than the yellow CPA when connecting the connector.


      • If the upper portion of the yellow CPA is held when connecting the connector, the partial connection prevention mechanism will not function due to deformation of the yellow CPA. Therefore, hold the sides of the yellow CPA.

  2. INSTALL FRONT SEATBACK STAY PROTECTOR

    Click here

  3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

    Click here

  4. INSTALL FRONT SEAT HEADREST SUPPORT

    Click here

  5. INSTALL SEAT SHOULDER BELT COVER LH

    Click here

  6. INSTALL FRONT SEAT OUTER TRACK COVER SUB-ASSEMBLY LH

    Click here

  7. INSTALL SEAT STAND FRAME CAP

    Click here

  8. INSTALL FRONT SEAT INNER ARMREST ASSEMBLY LH

    Click here

  9. INSTALL NO. 1 SEAT ARMREST CAP

    Click here

  10. INSTALL FRONT SEAT CUSHION SHIELD LH

    Click here

  11. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  12. INSTALL SEAT TRACK LOCK OPEN LEVER LH

    Click here

  13. INSTALL FRONT SEAT CUSHION LEVER

    Click here

  14. INSTALL FRONT SEAT CUSHION SHIELD LH

    Click here

  15. INSTALL NO. 1 SEAT LEG COVER SUB-ASSEMBLY

    Click here

  16. INSTALL NO. 1 SEAT LEG COVER SUB-ASSEMBLY

    Click here

  17. INSTALL FRONT SEAT LEG COVER

    Click here

  18. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  20. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  21. CHECK SRS WARNING LIGHT

    Click here