CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the curtain shield airbag assembly removal/installation are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Disconnect cable from negative (-) battery terminal Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes) Stop and start system

Click here

Correct the steering angle neutral point Panoramic view monitor system

Click here

Servo motor initialization Air conditioning system

Click here

Reset slide door close position Power slide door system

Click here

Reset back door close position Back door opener

Click here

Initialize back door lock Power door lock control system

Click here

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    B006M99

    Click here

    Click here

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    B006LHC

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

    CAUTION:

    B006N9HC01
    B006PCE Deployment side

    • When storing the curtain shield airbag assembly LH, keep the airbag deployment side facing upward.

    • If the airbag deploys for any reason, it may cause a serious accident.


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

      B006LHC

    3. Using a screwdriver, pull up the connector lock and disconnect the 2 airbag connectors.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

      Tech Tips

      Tape the screwdriver tip before use.

      B006QYCC01
      *a Connector Lock - -
      B006PCE Protective Tape B006N8A Release in this Direction

    4. Using needle-nose pliers, release the lock by pinching the 2 locks of the pin, and then pull out the pin from the clip.

      Note

      The pin must not be reused.

      Tech Tips

      Use the same procedure for the other pin.

    5. Using 2 screwdrivers, detach the clip by inserting the screwdrivers into the groove of the clip as shown in the illustration, and then remove the clip from the vehicle body.

      Tech Tips

      Use the same procedure for the other clip.

      B006QHRC01
      *a Pin - -
      B006N8A Pull Out in this Direction - -

    6. Remove the 6 bolts.

      Note

      The bolts must not be reused.

    7. Detach the clip and remove the curtain shield airbag assembly LH.

      B006OA0