FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY


    1. B006LXCC01
      B006N8A Slowly Pull

      Attach the hook on the side of the airbag door facing the front of the vehicle and set the instrument panel passenger airbag assembly onto the airbag door.

    2. Slowly pull the instrument panel passenger airbag assembly in the direction indicated by the arrow shown in the illustration to attach the hook on the side of the airbag door facing the rear of the vehicle and install the instrument panel passenger airbag assembly.

    3. Install the 2 screws.

    4. Attach the hook to connect the pad.

  2. INSTALL NO. 2 INSTRUMENT PANEL WIRE


    1. B006N74C01
      *a Connector Lock
      B006N8A Push in this Direction

      Attach the wire harness clamp to install the No. 2 instrument panel wire.

    2. Connect the airbag connector and push the connector lock.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

  3. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY

    for LHD:

    Click here

    for RHD:

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  6. CHECK SRS WARNING LIGHT

    Click here