DIGITAL REAR-VIEW MIRROR SYSTEM OPERATION CHECK

Tech Tips


  • It is only necessary to perform an inspection when there are dents or distortion in the back door panel sub-assembly as a result of an accident.

  • Inspections are not required when replacing parts or removing and reinstalling.


  1. Camera image range confirmation procedure


    1. Set the vehicle in the position shown in the illustration and create a target on the wall.

      Note


      • Perform on a level surface.

      • Remove all luggage from the vehicle before starting work.

      • Adjust the tire pressures to the specified pressure before starting work.

      B006PAAC01
      *1 Vehicle Center *2 Wall, etc.
      *3 Target *4 Vehicle Rear End
      *5 100 cm (3.28 ft.) *6 133 cm (4.36 ft.)
      *7 35 cm (1.14 ft.) *8 2.4 cm (0.944 in.)
    2. B006KZOC02
      *a Inner Rear View Mirror Assembly
      *1 Target

      With the engine switch on (IG), turn the display on (digital mirror mode) and check that the target is recognized on the inner rear view mirror assembly.

      Tech Tips


      • Set the display settings to the initial settings (position, zoom [enlargement/reduction])

      • If the target is properly displayed, there is no problem with the positioning and the digital inner mirror system is normal.