COMBINATION METER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the combination meter installation/removal are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative Functions when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system (for 2AR-FE)	Click here
		Stop and start system (for 2GR-FKS)	Click here
	Memorize steering angle neutral point	Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here

PROCEDURE

PRECAUTION

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (for Separate Console Box Type)

Click here
REMOVE CENTER NO. 2 INSTRUMENT CLUSTER FINISH PANEL (for Separate Console Box Type)

Tech Tips

Use the same procedure as for the center No. 1 instrument cluster finish panel. (for Separate Console Box Type)
REMOVE NO. 2 BOX BOTTOM MAT (for Integrated Console Box Type)

Click here
REMOVE INSTRUMENT PANEL FINISH PANEL END LH (for Integrated Console Box Type)

Click here
REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for Integrated Console Box Type)

Tech Tips

Use the same procedure as for the instrument panel finish panel end LH. (for Integrated Console Box Type)
REMOVE UPPER INSTRUMENT PANEL FINISH PANEL

Click here
REMOVE INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Click here
REMOVE COMBINATION METER ASSEMBLY
1. Remove in this Direction
  
  Disengage the claws to pull the combination meter assembly as shown in the illustration.
2. Disengage the clamp.
3. Disconnect the 2 connectors to remove the combination meter assembly.