ILLUMINATION ECU REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the room light control relay removal / installation are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here

PROCEDURE

REMOVE ROOF HEADLINING ASSEMBLY

Click here
REMOVE ROOM LIGHT CONTROL RELAY
1. Disconnect the connector.
2. Remove in this Direction
  
  Detach the claw and slide the room light control relay as shown in the illustration and remove it.