BACK DOOR COURTESY SWITCH INSPECTION

PROCEDURE


  1. INSPECT BACK DOOR LOCK ASSEMBLY(BACK DOOR COURTESY SWITCH)


    1. Check the operation.


      1. A01IGW3C03
        *a

        Component without harness connected

        (Back Door Lock Assembly (Closer Motor))
        *b Close Operation Direction
        *c Close Operation Direction

        Apply battery voltage and check the operation of the closer motor.

        OK
        Battery Connection Result

        Battery positive(+) → 1(M-)

        Battery negative(-) → 4(M+)

        		 Close Operation

        Battery positive(+) → 4(M+)

        Battery negative(-) → 1(M-)

        		 Open Operation

        If the result is not as specified, replace the back door lock assembly (closer motor)

    2. A01IKSMC05
      *a

      Component without harness connected

      (Back Door Lock Assembly (Back Door Courtesy Switch))
      *b Open Position
      *c Half-latch Position
      *d Full-latch Position
      *e Overstroke Position

      Inspect the back door courtesy switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        7(E) - 8(CTY) Open position Below 1 Ω
        7(E) - 8(CTY) Half-latch position Below 1 Ω
        7(E) - 8(CTY) Half-latch position → Full-latch position Below 1 Ω → 10 kΩ or higher
        7(E) - 8(CTY) Full-latch position 10 kΩ or higher
        7(E) - 8(CTY) Overstroke position 10 kΩ or higher

        If the result is not as specified, replace the back door lock assembly (back door courtesy switch)