SPOT LIGHT REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the No. 2 spot light assembly removal/installation are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and Start System (for 2AR-FE)

Click here

Stop and Start System (for 2GR-FKS)

Click here

Memorize steering angle neutral point Panoramic View Monitor System

Click here

Initialize back door lock Power Door Lock Control System

Click here

Initialize servo motor Air Conditioning System

Click here

Reset slide door close position Power Slide Door System

Click here

Reset back door close position Power Back Door System

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  2. REMOVE NO. 2 SPOT LIGHT ASSEMBLY LH


    1. B006PZS

      Remove the duct.

    2. B006KM5

      Disconnect the connector.

    3. B006KPK

      Remove the screw.

    4. B006RJO

      Detach the claw.

    5. B006R8C

      Detach the claw and guide and remove the No. 2 spot light assembly LH.