ELECTRICAL KEY OSCILLATOR(for Rear Floor) REMOVAL

PROCEDURE


  1. REMOVE REAR NO. 1 SEAT ASSEMBLY LH


    1. for Power Captain Seat with Memory:

      Click here

    2. for Power Captain Seat without Memory:

      Click here

    3. for Manual Captain Seat:

      Click here

  2. REMOVE REAR NO. 1 SEAT ASSEMBLY RH


    1. for Power Captain Seat with Memory:

      Tech Tips

      Use the same procedure as for the LH side.

    2. for Power Captain Seat without Memory:

      Tech Tips

      Use the same procedure as for the LH side.

    3. for Manual Captain Seat:

      Tech Tips

      Use the same procedure as for the LH side.

  3. REMOVE REAR SEAT TRACK SLIDE STOPPER

    Click here

  4. REMOVE REAR SEAT LOCK STRIKER COVER LH

    Click here

  5. REMOVE REAR SEAT LOCK STRIKER COVER RH

    Tech Tips

    Use the same procedure as for the LH side.

  6. REMOVE REAR NO. 3 FLOOR BOARD ASSEMBLY

    Click here

  7. REMOVE UTILITY BOX SUB-ASSEMBLY

    Click here

  8. REMOVE REAR UPPER NO. 3 FLOOR BOARD PLATE

    Click here

  9. REMOVE NO. 3 FLOOR CARPET MOULDING

    Click here

  10. REMOVE LOWER SEAT TRACK RAIL PROTECTOR

    Click here

  11. DISCONNECT REAR FLOOR MAT ASSEMBLY RH


    1. B006OC2C01
      B006QOD Peel back

      Peel back the rear floor mat assembly RH to the extent that the No. 3 indoor electrical key antenna assembly can be removed.

      Note

      Do not use excessive force when peeling back the rear floor mat assembly RH to prevent the foam pad from tearing.

  12. REMOVE NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY


    1. B006P94C01
      B006N8A Remove in this Direction

      Disconnect the connector.

    2. Disengage the claws to remove the No. 3 indoor electrical key antenna assembly as shown in the illustration.

      Note

      Be careful when installing the No. 3 indoor electrical key antenna assembly. If the No. 3 indoor electrical key antenna assembly is dropped, replace it with a new one.