BACK DOOR LOCK INSTALLATION

PROCEDURE

1. INSTALL BACK DOOR LOCK ASSEMBLY

   Tech Tips

   
   

   • Make sure to remove the string before installing a new back door lock assembly.

   • The string can be removed from the back door lock assembly by pulling it out from either end.

   
   

   1. Apply MP grease to the sliding parts of the back door lock assembly.

   2. 

      Install in this Direction

      Install the back door lock assembly with the 4 bolts as shown in the illustration.

      Torque:

      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }

   3. Engage the clamp to connect the wire harness.

   4. Connect the connector.

2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY

   Click here

3. INSTALL SWITCH BEZEL (w/ Power Back Door)

   Click here

4. INSTALL BACK DOOR INSIDE HANDLE

   Click here

5. INSTALL BACK DOOR SIDE GARNISH LH (w/ Power Back Door)

   Click here

6. INSTALL BACK DOOR SERVICE HOLE COVER LH (w/ Power Back Door)

   Click here

7. INSTALL BACK DOOR SIDE GARNISH LH (w/o Power Back Door)

   Click here

8. INSTALL BACK DOOR SIDE GARNISH RH

   Click here

9. INSTALL BACK DOOR CENTER GARNISH

   Click here