CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
PROCEDURE
INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH
| *a | Bracket |
Attach the 2 guides to install the retractor of the rear No. 2 seat outer belt assembly LH with the bolt.
Note
Make sure that the retractor is not tilted.
Make sure that the bracket is not deformed.
|
Cover Closing Direction |
Connect the No. 2 seat outer belt assembly LH with the bolt.
INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (for Floor Anchor)
Check that the rear No. 2 seat outer belt assembly LH is not twisted.
Connect the floor anchor of the rear No. 2 seat outer belt assembly LH with the bolt.
INSTALL REAR QUARTER TRIM PANEL ASSEMBLY LH
INSTALL ROPE HOOK ASSEMBLY
INSTALL NO. 2 LUGGAGE COMPARTMENT TRIM HOOK
INSTALL DECK SIDE GARNISH LH
INSTALL REAR UPPER NO. 2 FLOOR BOARD PLATE
INSTALL BACK DOOR SCUFF PLATE
INSTALL UTILITY BOX SUB-ASSEMBLY
INSTALL REAR NO. 3 FLOOR BOARD ASSEMBLY
INSTALL REAR NO. 2 FLOOR BOARD ASSEMBLY
INSTALL REAR NO. 1 FLOOR BOARD ASSEMBLY
INSTALL REAR DOOR SCUFF PLATE LH
INSTALL REAR NO. 2 SEAT ASSEMBLY
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.