REAR NO. 1 SEAT OUTER BELT ASSEMBLY(for Power Captain Seat with Memory) INSPECTION

PROCEDURE

1. INSPECT NO. 1 SEAT 3 POINT TYPE BELT ASSEMBLY LH

   
   
   1. 

      *a	Unlock
      *b	Lock
      *c	45°

      Before installing the No. 1 seat 3 point type belt assembly LH, check the ELR function.

      Note

      Do not disassemble the retractor.

      
      

      1. When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

         If the result is not as specified, replace the No. 1 seat 3 point type belt assembly LH.

   2. Check the tension reducer operation.

      
      
      1. 

         *a	Component without harness connected (Front Seat Outer Belt Assembly LH)
         *b	Tension Reducer Connector

         Connect the positive (+) lead of the battery to terminal 1 of the tension reducer connector and the negative (-) lead to terminal 2.

      2. Check that an operating sound is heard when the magnetized solenoid is attracting the plunger.

      3. Pull out the seat belt and let it retract. Listen to the operating sound.

      4. Pull out the seat belt again, disconnect the negative (-) lead of the battery and let it retract. Listen to the operating sound again and check that the operating sound volume has increased.

         If the result is not as specified, replace the front seat outer belt assembly LH.

2. INSPECT NO. 1 SEAT 3 POINT TYPE BELT ASSEMBLY RH

   
   
   1. 

      *a	Unlock
      *b	Lock
      *c	45°

      Before installing the No. 1 seat 3 point type belt assembly RH, check the ELR function.

      Note

      Do not disassemble the retractor.

      
      

      1. When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

         If the result is not as specified, replace the No. 1 seat 3 point type belt assembly RH.

   2. Check the tension reducer operation.

      
      
      1. 

         *a	Component without harness connected (Front Seat Outer Belt Assembly RH)
         *b	Tension Reducer Connector

         Connect the positive (+) lead of the battery to terminal 1 of the tension reducer connector and the negative (-) lead to terminal 2.

      2. Check that an operating sound is heard when the magnetized solenoid is attracting the plunger.

      3. Pull out the seat belt and let it retract. Listen to the operating sound.

      4. Pull out the seat belt again, disconnect the negative (-) lead of the battery and let it retract. Listen to the operating sound again and check that the operating sound volume has increased.

         If the result is not as specified, replace the front seat outer belt assembly RH.