REAR NO. 2 SEAT INNER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

PROCEDURE


  1. INSTALL NO. 2 SEAT LAP TYPE BELT ASSEMBLY


    1. A01IFWNC01
      B006N8A Install in this Direction

      Pass the rear No. 2 seat inner belt assembly RH and No. 2 seat lap type belt assembly through the hole of the separate type rear seat cushion cover with pad as shown in the illustration.

    2. A01IFA7

      Install the No. 2 seat lap type belt assembly.

  2. INSTALL REAR NO. 2 SEAT INNER BELT ASSEMBLY RH


    1. A01IEMTC01
      *a Protruding Part

      Install the rear No. 2 seat inner belt assembly RH and No. 2 seat lap type belt assembly with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note

      Do not allow the anchor part of the No. 2 seat lap type belt assembly to overlap the protruding part of the rear No. 2 seat adjuster.

    2. Install a new clamp and cut it at the position shown in the illustration.

      A01IJRZC01
      *a Cut - -
      Standard
      Area Measurement
      a 10.0 mm (0.3937 in.)

  3. INSTALL REAR NO. 2 SEAT LAP TYPE BELT ASSEMBLY

    Tech Tips

    Use the same procedure as for the RH side.

  4. INSTALL REAR NO. 2 SEAT INNER BELT ASSEMBLY LH

    Tech Tips

    Use the same procedure as for the RH side.

  5. INSTALL SEAT LEG COVER


    1. A01IKHGC01
      B006N8A Install in this Direction

      Install the seat leg cover as shown in the illustration.

    2. A01IIAA

      Install the seat leg cover with the 3 clips.

  6. INSTALL NO. 2 SEAT CUSHION STOPPER

    Click here

  7. INSTALL REAR NO. 2 SEAT ASSEMBLY LH

    Click here

  8. INSTALL REAR NO. 2 SEAT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.