REAR NO. 1 SEAT INNER BELT ASSEMBLY(for Power Captain Seat with Memory) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH


    1. B006QJ6C01
      *a Protruding Part
      B006N8A Install in this Direction

      Install the rear No. 1 seat inner belt assembly LH with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note

      Do not allow the anchor part of the rear No. 1 seat inner belt assembly LH to overlap the protruding part of the front seat adjuster.

    2. B006MEU

      Attach the wire harness clamp.

    3. Connect the connector.

  2. INSTALL REAR NO. 1 SEAT INSIDE RECLINING ADJUSTER COVER

    Click here

  3. INSTALL REAR SEAT ARMREST FRAME SUB-ASSEMBLY RH

    Click here

  4. INSTALL REAR SEAT TURN TABLE ASSEMBLY LH

    Click here

  5. INSTALL REAR NO.1 SEAT LEG BRACKET

    Click here

  6. INSTALL REAR NO. 1 SEAT ARMREST ASSEMBLY RH

    Click here

  7. INSTALL REAR SEAT CUSHION MOULDING LH

    Click here

  8. INSTALL SEAT ADJUSTER COVER CAP RH (w/o Manual Walk-in Mechanism)

    Click here

  9. INSTALL SEAT ADJUSTER COVER CAP LH (w/ Manual Walk-in Mechanism)

    Click here

  10. INSTALL RECLINING ADJUSTER COVER RH

    Click here

  11. INSTALL REAR NO. 1 SEAT ASSEMBLY LH

    Click here