FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart.

    Click here

PROCEDURE


  1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. B006P8F

      Attach the guide and install the front shoulder belt anchor adjuster assembly with the 2 bolts.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH


    1. B006QQ5

      Attach the 2 guides and install the front seat outer belt assembly LH with the bolt.

      Torque:
      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }
    2. B006KLVC01
      *1 Locking Button

      Connect the pretensioner connector and lock the locking button as shown in the illustration.

      Note

      Securely lock the locking button.

    3. B006MGC

      Connect the shoulder anchor of the front seat outer belt assembly LH with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    4. Connect the floor anchor of the front seat outer belt assembly LH with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    5. Check that the ELR locks.

      Note

      The check should be performed with the front seat outer belt assembly installed.


      1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.

    6. Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly LH.

  3. INSTALL SHOULDER BELT ANCHOR COVER LH

    Tech Tips

    Perform this procedure when replacing the shoulder belt anchor cover LH


    1. B006KMKC01

      Attach the guide and install the shoulder belt anchor cover LH in the order indicated in the illustration.

  4. INSTALL CENTER PILLAR GARNISH LH

    Click here

  5. INSTALL LOWER CENTER PILLAR GARNISH LH

    Click here

  6. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH (for Floor Anchor)


    1. B006PRN

      except Super Long Slide Seat:

      Connect the anchor of the front seat outer belt assembly LH with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  7. INSTALL OUTER LAP BELT ANCHOR COVER

    Tech Tips


    • Use the same procedure for outer lap belt anchor covers.

    • For the LH side, use the same procedure for vehicles without super long slide seat.


    1. B006MERC01
      B006N8A Install in this Direction

      Attach the claw to install the outer lap belt anchor cover as shown in the illustration.

  8. INSTALL NO. 2 ASSIST GRIP

    Click here

  9. INSTALL ASSIST GRIP PLUG

    Click here

  10. INSTALL ASSIST GRIP PLUG

    Click here

  11. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  12. INSTALL DOOR SCUFF PLATE ASSEMBLY LH

    Click here

  13. INSTALL COWL SIDE TRIM BOARD LH

    Click here

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  15. CHECK SRS WARNING LIGHT

    Click here