SEAT HEATER CONTROL(for Front Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the front seat heater control sub-assembly removal/installation are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative Functions when not Performed	Link
Disconnect cable from negative (-) battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and Start System (for 2AR-FE)	Click here
		Stop and Start System (for 2GR-FKS)	Click here
	Memorize steering angle neutral point	Panoramic View Monitor System	Click here
	Initialize back door lock	Power Door Lock Control System	Click here
	Initialize servo motor	Air Conditioning System	Click here
	Reset slide door close position	Power Slide Door System	Click here
	Reset back door close position	Power Back Door System	Click here

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.

PROCEDURE

REMOVE FRONT SEAT ASSEMBLY LH (for Driver Side)

Click here
REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH (for Driver Side)
1. Disconnect the 2 connectors.
2. Detach the clamp and remove the seat heater control LH.
REMOVE FRONT SEAT ASSEMBLY RH (for Front Passenger Side)

Click here
REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY RH (for Front Passenger Side)
1. Disconnect the 2 connectors.
2. Detach the clamp and remove the seat heater control RH.