SEAT HEATER CONTROL REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization, or registration) that must be per formed after parts are removed, installed, or replaced during the seat heater control removal / installation are shown below.

Additional Work After Servicing
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative Functions when not Performed	Link
Disconnect cable from negative (-) battery terminal	Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes)	Stop and start system	Click here
	Correct the steering angle neutral point	Panoramic view monitor system	Click here
	Servo motor initialization	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Back door opener	Click here
	Initialize back door lock	Initialize back door lock	Click here

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

PROCEDURE

REMOVE FRONT SEAT ASSEMBLY LH (for Driver Side)

Click here
REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH (for Driver Side)
1. Disconnect the 2 connectors.
2. Detach the clamp and remove the seat heater control LH.
REMOVE FRONT SEAT ASSEMBLY RH (for Front Passenger Side)

Click here
REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY RH (for Front Passenger Side)
1. Disconnect the 2 connectors.
2. Detach the clamp and remove the seat heater control RH.