FRONT SEAT CUSHION HEATER(for Front Passenger Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization, or registration) that must be per formed after parts are removed, installed, or replaced during the front seat cushion heater (for front passenger seat) removal / installation are shown below.

Additional Work After Servicing
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative Functions when not Performed	Link
Disconnect cable from negative (-) battery terminal	Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes)	Stop and start system	Click here
	Correct the steering angle neutral point	Panoramic view monitor system	Click here
	Servo motor initialization	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Back door opener	Click here
	Initialize back door lock	Initialize back door lock	Click here

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
Replace any other damaged parts as necessary.

Tech Tips

Use the same procedure for RHD and LHD vehicles.

The procedure listed below is for LHD vehicles.

PROCEDURE

REMOVE FRONT SEAT ASSEMBLY RH

Click here
REMOVE SEAT ADJUSTER COVER CAP RH

Click here
REMOVE FRONT SEAT LEG ASSEMBLY RH

Click here
REMOVE FRONT SEAT LEG COVER

Click here
REMOVE POWER SEAT SWITCH KNOB RH (for Slide)

Click here
REMOVE POWER SEAT SWITCH KNOB RH (for Reclining)

Click here
REMOVE FRONT SEAT CUSHION SHIELD RH

Click here
REMOVE FRONT SEAT INNER CUSHION SHIELD RH

Click here
REMOVE FRONT SEAT INNER BELT ASSEMBLY RH

Click here
REMOVE SEAT CUSHION COVER WITH PAD

Click here
REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

Click here
REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY RH
1. Disconnect the 34 tack pins and remove the front seat cushion heater assembly RH.