FRONT SEATBACK HEATER(for Driver Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization, or registration) that must be per formed after parts are removed, installed, or replaced during the front seatback heater (for driver seat) removal / installation are shown below.

Additional Work After Servicing
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Disconnect cable from negative (-) battery terminal Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes) Stop and start system

Click here

Correct the steering angle neutral point Panoramic view monitor system

Click here

Servo motor initialization Air conditioning system

Click here

Reset slide door close position Power slide door system

Click here

Reset back door close position Back door opener

Click here

Initialize back door lock Initialize back door lock

Click here

CAUTION:


  • B006LWS

    Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

  • If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

  • Replace any other damaged parts as necessary.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.


  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  2. REMOVE SEAT ADJUSTER COVER CAP LH

    Click here

  3. REMOVE FRONT SEAT LEG ASSEMBLY LH

    Click here

  4. REMOVE FRONT SEAT LEG COVER

    Click here

  5. REMOVE POWER SEAT SWITCH KNOB LH (Slide and Vertical, Lifter)

    Click here

  6. REMOVE POWER SEAT SWITCH KNOB LH (for Reclining)

    Click here

  7. REMOVE FRONT SEAT INNER NO. 1 CUSHION SHIELD LH

    Click here

  8. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  9. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  10. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH

    Click here

  11. REMOVE ASSIST GRIP PLUG

    Click here

  12. REMOVE ASSIST GRIP

    Click here

  13. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH

    Click here

  14. REMOVE FRONT SEAT HEADREST SUPPORT

    Click here

  15. REMOVE SEATBACK COVER WITH PAD

    Click here

  16. REMOVE SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  17. REMOVE FRONT SEATBACK HEATER ASSEMBLY LH


    1. A01IJOJ

      Disconnect the 18 tack pins and remove the front seatback heater assembly LH.