POWER SEAT SWITCH(for Driver Seat) REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the power seat switch (for driver seat) removal/installation are shown below.
| Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative Functions when not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative (-) battery terminal | Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) | Stop and Start System (for 2AR-FE) | |
| Stop and Start System (for 2GR-FKS) | |||
| Memorize steering angle neutral point | Panoramic View Monitor System | ||
| Initialize back door lock | Power Door Lock Control System | ||
| Initialize servo motor | Air Conditioning System | ||
| Reset slide door close position | Power Slide Door System | ||
| Reset back door close position | Power Back Door System |
CAUTION:
-
Wear protective gloves. Sharp areas on the parts may injure your hands.
-
There is risk of injury.
-
If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
-
Replace any other damaged parts as necessary.
Tech Tips
-
Use the same procedure for RHD and LHD vehicles.
-
The procedure listed below is for LHD vehicles.
PROCEDURE
-
REMOVE FRONT SEAT ASSEMBLY LH
-
REMOVE SEAT ADJUSTER COVER CAP LH
-
REMOVE FRONT SEAT LEG ASSEMBLY LH
-
REMOVE FRONT SEAT LEG COVER
-
REMOVE FRONT SEAT INNER NO. 1 CUSHION SHIELD LH
-
REMOVE POWER SEAT SWITCH KNOB LH (for Slide and Vertical, Lifter)
-
REMOVE POWER SEAT SWITCH KNOB LH (for Reclining)
-
REMOVE FRONT SEAT CUSHION SHIELD LH
-
REMOVE FRONT POWER SEAT SWITCH LH
-
Remove the 3 screws and front power seat switch RH.
-