BLIND SPOT MONITOR SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Avoid any impact to the blind spot monitor sensor.

  • Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.

Tech Tips


  • The blind spot monitor beam axis confirmation is performed to confirm whether the sensor beam axis is correct, and to adjust the beam axis by using a reflector.

  • The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is perpendicular to the floor surface (+/-5°) by using a jig, and that the sensor is 46 to 54° from the line parallel to the vehicle center line.

PROCEDURE


  1. INSTALL BLIND SPOT MONITOR BRACKET LH


    1. Install the blind spot monitor bracket LH with the 3 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. INSTALL BLIND SPOT MONITOR BRACKET RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. INSTALL BLIND SPOT MONITOR SENSOR LH


    1. Connect the connector.

    2. Install the blind spot monitor sensor LH with the 3 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  4. INSTALL BLIND SPOT MONITOR SENSOR RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. PERFORM BLIND SPOT MONITOR SENSOR INSTALLATION CONDITION INSPECTION

    Click here

  6. INSTALL REAR BUMPER COVER UPR LH

    Click here

  7. INSTALL REAR BUMPER COVER UPR RH

    Tech Tips

    Use the same procedure described for the LH side.

  8. INSTALL REAR BUMPER ASSEMBLY

    Click here

  9. PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION

    Click here

    SST
    09870-60000   ( 09870-60010 )

  10. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here