BLIND SPOT MONITOR SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Blind spot monitor sensor Blind spot monitor beam axis adjustment Blind spot monitor system

Click here

PROCEDURE


  1. REMOVE REAR BUMPER ASSEMBLY

    Click here

  2. REMOVE REAR BUMPER COVER UPR LH

    Click here

  3. REMOVE REAR BUMPER COVER UPR RH

    Tech Tips

    Use the same procedure described for the LH side.

  4. REMOVE BLIND SPOT MONITOR SENSOR LH


    1. B006PB6

      Disconnect the connector.

    2. Remove the 3 nuts and blind spot monitor sensor LH.

      Note

      Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.

  5. REMOVE BLIND SPOT MONITOR SENSOR RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. REMOVE BLIND SPOT MONITOR BRACKET LH


    1. B006QRM

      Remove the 3 nuts and blind spot monitor bracket LH.

  7. REMOVE BLIND SPOT MONITOR BRACKET RH

    Tech Tips

    Use the same procedure described for the LH side.