PANORAMIC VIEW MONITOR SYSTEM, Diagnostic DTC:C1697

DTC Code DTC Name
C1697 Camera Position Adjustment Incomplete

DESCRIPTION

This DTC is stored when the parking assist ECU judges that the camera initial setting has not been memorized (camera view adjustment is incomplete).

DTC No. Detection Item DTC Detection Condition Trouble Area
C1697 Camera Position Adjustment Incomplete Camera initial setting has not been memorized

  • Camera view adjustment

  • Parking assist ECU

CAUTION / NOTICE / HINT

Note


  • When "System initializing" is displayed on the parking assist ECU after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here

PROCEDURE


  1. ADJUST SETTINGS (CAMERA VIEW ADJUSTMENT)


    1. Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.


      1. Refer to camera view adjustment.

        Click here

      Result
      Proceed to
      NEXT

    NEXT

  2. CHECK FOR DTC


    1. Clear the DTCs.

      Click here


      Chassis > Panoramic View Monitor > Clear DTCs

    2. Check for DTCs.

      Click here


      Chassis > Panoramic View Monitor > Trouble Codes
      OK
      DTC C1697 is not output.

      Tech Tips


      • If DTC C1697 is output, perform the camera view adjustment again.

      • If DTC C1697 is still output after performing the camera view adjustment 3 times, replace the parking assist ECU.

      Result
      Proceed to
      OK
      NG

    OK

    END (CAMERA VIEW ADJUSTMENT IS DEFECTIVE)

    NG

    REPLACE PARKING ASSIST ECU Click here