ULTRASONIC SENSOR(for Front) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the No. 1 ultrasonic sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Removal/installation of radiator grill Front television camera view adjustment Panoramic view monitor system

Click here

PROCEDURE


  1. REMOVE RADIATOR GRILLE (for ALPHARD)

    Click here

  2. REMOVE RADIATOR GRILLE (for VELLFIRE)

    Click here

  3. REMOVE FRONT BUMPER COVER (for ALPHARD)

    Click here

  4. REMOVE FRONT BUMPER COVER (for VELLFIRE)

    Click here

  5. REMOVE ULTRASONIC SENSOR CLIP

    Tech Tips

    Use the same procedure for both sides.


    1. A01IFQGC01
      B006N8A Remove in this Direction

      Disengage the clamp.

    2. Disengage the claws to remove the ultrasonic sensor clip as shown in the illustration.

  6. REMOVE NO. 1 ULTRASONIC SENSOR

    Tech Tips

    Use the same procedure for both sides.


    1. A01IKEC

      Disconnect the connector.

    2. A01IFU1C01
      B006N8A Remove in this Direction (1)
      B006NJK Remove in this Direction (2)
      B006N3W Remove in this Direction (3)

      Disengage the claws as shown in the illustration to remove the No. 1 ultrasonic sensor.