CLEARANCE WARNING ECU REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the clearance warning ECU removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start controlis permitted (approximately 15 to 40minutes) Stop and start system

Click here

Memorize steering angle neutral point Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Initialize servo motor Air conditioning system

Click here

Reset slide door close position Power slide door system

Click here

Reset back door close position Power back door system

Click here

PROCEDURE


  1. REMOVE COMBINATION METER ASSEMBLY

    Click here

  2. REMOVE CLEARANCE WARNING ECU ASSEMBLY


    1. B006OM9

      Remove the bolt.

    2. Disengage the hook and raise the clearance warning ECU assembly.

    3. B006N9E

      Disconnect the connector to remove the clearance warning ECU assembly.