BLIND SPOT MONITOR SYSTEM Power Source Circuit

DESCRIPTION

This circuit provides power to operate the blind spot monitor sensor.

WIRING DIAGRAM

B006NO8E02

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH (MASTER) POWER SOURCE)

    B006NDLC27
    *a

    Front view of wire harness connector

    (to blind spot monitor sensor LH (Master))

    1. Disconnect the blind spot monitor sensor LH (Master) connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      K40-5 (BLB) - Body ground Engine switch on (IG) 11 to 14 V
      K40-5 (BLB) - Body ground Engine switch off Below 1 V
      Result
      Result Proceed to
      OK A
      NG (for 2AR-FE) B
      NG (for 2GR-FKS) C

    B

    GO TO STOP AND START SYSTEM Click here

    C

    GO TO STOP AND START SYSTEM Click here

    A

  2. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH (MASTER) - BODY GROUND)


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      K40-10 (BLGD) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH (SLAVE) POWER SOURCE)

    B006NDLC28
    *a

    Front view of wire harness connector

    (to Blind Spot Monitor Sensor RH (Slave))

    1. Disconnect the blind spot monitor sensor RH (Slave) connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      L40-5 (BRB) - Body ground Engine switch on (IG) 11 to 14 V
      L40-5 (BRB) - Body ground Engine switch off Below 1 V
      Result
      Result Proceed to
      OK A
      NG (for 2AR-FE) B
      NG (for 2GR-FKS) C

    B

    GO TO STOP AND START SYSTEM Click here

    C

    GO TO STOP AND START SYSTEM Click here

    A

  4. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH (SLAVE) - BODY GROUND)


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L40-10 (BRGD) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR