ULTRASONIC SENSOR(for Front) INSTALLATION

PROCEDURE


  1. INSTALL FRONT CORNER ULTRASONIC SENSOR RETAINER

    Note


    • Installing the front corner ultrasonic sensor retainer with some double-sided tape remaining may cause poor adhesion. Perform this procedure until sufficiently removed it.

    • Make sure to use a cloth when removing. Using a screwdriver, etc., may cause damage and poor adhesion.


    1. Clean the front bumper assembly surface.


      1. Remove any remaining double-sided tape from the front bumper assembly.

      2. Wipe off any tape adhesive residue with cleaner.

    2. B006RBQC04
      *a 30 mm (1.18 in.)

      Cover the sensor installation hole form the outside of the bumper cover with a 30 mm (1.18 in.) square piece of tape.

    3. B006KSGC04
      *a Scribed Line
      B006REL Primer Application

      Apply primer to front bumper assembly on the installation area of the front corner ultrasonic sensor retainer using a brush or felt.

      Note


      • Replace the brush or felt if it is dirty or has become hardened.

      • Keep any painted surface free from primer.

      • If the primer contacts a painted surface, it may leave light primer marks. Therefore, use protective tape when using liquid primer.

      • Do not touch surfaces to which primer has been applied until the front corner ultrasonic sensor retainer has been attached.

    4. Let the primer dry sufficiently.

      Note

      Do not touch applied surfaces until the primer is dry.

      Recommended drying time
      10 minutes or more (at 23 °C (73 °F))

    5. Confirm that the primer has completely dried by touching the front bumper assembly. Then remove the tape.

    6. Remove the peeling paper of the new front corner ultrasonic sensor retainer trying not to touch the adhesional surface.

      Note

      After removing the peeling paper, do not touch the surface of the tape with your fingers or cotton work gloves

    7. B006OU5C04
      *a Scribed Line

      Align the front corner ultrasonic sensor retainer with the scribed line on the front bumper assembly and install it as shown in the illustration.

      Note

      The application strength of the front corner ultrasonic sensor retainer will weaken if reapplied. If reapplication is necessary, be sure to replace it with a new one.

      Tech Tips


      • Apply pressure so that it does not lift up from the front bumper assembly.

      • Pushing force: 30 N (3.0 kgf) for 3 seconds

  2. INSTALL ULTRASONIC SENSOR CLIP

    Tech Tips


    • Perform this procedure only when replacement of the ultrasonic sensor clip is necessary.

    • Use the same procedure for all ultrasonic sensor clips.


    1. Engage the clamp to install the ultrasonic sensor clip to the wire.

  3. INSTALL FRONT CORNER ULTRASONIC SENSOR

    Tech Tips

    Use the same procedure for both sides.


    1. Engage the claws to install the front corner ultrasonic sensor.

    2. Connect the connector.

    3. B006P0DC02
      B006N8A Install in this Direction

      Engage the claw as shown in the illustration.

  4. INSTALL FRONT BUMPER COVER (for ALPHARD)

    Click here

  5. INSTALL FRONT BUMPER COVER (for VELLFIRE)

    Click here

  6. INSTALL RADIATOR GRILLE (for ALPHARD)

    Click here

  7. INSTALL RADIATOR GRILLE (for VELLFIRE)

    Click here

  8. ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)

    Click here