TELEPHONE ANTENNA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the telephone antenna assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here

PROCEDURE

REMOVE FRONT ROOF HEADLINING TRIM SUB-ASSEMBLY

Click here
REMOVE TELEPHONE ANTENNA ASSEMBLY
1. Disconnect the connector.
2. Remove the bolt and washer and holder.
3. Remove the telephone antenna assembly with cover.
4. Remove in this Direction (1)
  
  Remove in this Direction (2)
  
  Disengage the claws and guides to remove the telephone antenna assembly from the antenna outer cover as shown in the illustration.
5. When reusing the telephone antenna assembly:
  1. Remove the seal.

	Remove in this Direction (1)
	Remove in this Direction (2)