TELEMATICS TRANSCEIVER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the telematics transceiver removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here
Telematics transceiver	Register vehicle information	Emergency call service	Click here

PROCEDURE

PRECAUTION

Click here
REMOVE NO. 3 FLOOR CARPET MOULDING

Click here
REMOVE REAR NO. 2 CONSOLE END PANEL GARNISH

Click here
REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY

Click here
REMOVE TELEMATICS TRANSCEIVER
1. Disconnect the 3 connectors.
2. Disengage the clamps to separate the wire harness.
3. Remove the 2 bolts.
4. Disengage the clip and guide to remove the telematics transceiver.