TELEMATICS SYSTEM(w/ Telematics Transceiver except G-BOOK), Diagnostic DTC:B1573, B15CB

DTC Code DTC Name
B1573 Disconnect/Short in Telephone Antenna Circuit
B15CB Telephone Antenna Disconnected

DESCRIPTION

These DTCs are stored when a malfunction occurs in the telephone antenna assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1573 Disconnect/Short in Telephone Antenna Circuit

Telephone antenna assembly impedance (Ω) is lower than the malfunction threshold for 10 seconds when the engine switch is on (IG).

(Short circuit)


  • Telematics transceiver

  • Telephone antenna assembly

  • No. 4 antenna cord sub-assembly

B15CB Telephone Antenna Disconnected

Telephone antenna assembly impedance (Ω) is higher than the malfunction threshold for 10 seconds when the engine switch is on (IG).

(Open circuit)


  • Telematics transceiver

  • Telephone antenna assembly

  • No. 4 antenna cord sub-assembly

WIRING DIAGRAM

B006R5PE01

CAUTION / NOTICE / HINT

Note

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click here

PROCEDURE


  1. CHECK DTC


    1. Turn the engine switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the engine switch on (IG) and wait for 10 seconds.

    4. Turn the GTS on.

    5. Check for DTCs and check that no DTCs are output.

      Click here


      Body Electrical > Telematics > Trouble Codes
      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    OK
    NG
  2. INSPECT TELEPHONE ANTENNA ASSEMBLY


    1. Remove the telephone antenna assembly.

      Click here

    2. B006QAIC16
      *a

      Component without harness connected

      (Telephone Antenna Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      4 - 4a Always 4 to 11 kΩ
      Result
      Proceed to
      OK
      NG

    NG
    OK
  3. INSPECT NO. 4 ANTENNA CORD SUB-ASSEMBLY


    1. Remove the No. 4 antenna cord sub-assembly.

      Click here

    2. B006KPBC01
      *a

      Component without harness connected

      (No. 4 Antenna Cord Sub-assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      TA-1 (TEL) - RA-4 Always Below 1 Ω
      TA-1a - RA-4a Always Below 1 Ω
      TA-1 (TEL) or RA-4 - Body ground Always 10 kΩ or higher
      TA-1a or RA-4a - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG
    OK
  4. REPLACE TELEMATICS TRANSCEIVER


    1. Replace the telematics transceiver with a new one.

      Click here

      Result
      Proceed to
      NEXT

    NEXT