NAVIGATION ANTENNA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the navigation antenna installation/removal are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Disconnect cable from negative battery terminal Correct the steering angle neutral point Panoramic view monitor system

Click here

Initialize servo motor Air conditioning system

Click here

Reset slide door close position Power slide door system

Click here

Reset back door close position Power back door system

Click here

PROCEDURE


  1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

    Click here

  2. REMOVE CENTER DEFROSTER NOZZLE ASSEMBLY

    Click here

  3. REMOVE NAVIGATION ANTENNA ASSEMBLY


    1. B006QDK

      Disengage the claws.

    2. Disconnect the connector.

    3. B006PEA

      Remove the 2 screws and navigation antenna assembly with bracket.

    4. B006MBCC01
      B006N8A Remove in this Direction

      Disengage the claws.

    5. Disengage the guides to remove the navigation antenna assembly as shown in the illustration.