NAVIGATION RECEIVER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the navigation receiver installation/removal are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Disconnect cable from negative battery terminal Correct the steering angle neutral point Panoramic view monitor system

Click here

Initialize servo motor Air conditioning system

Click here

Reset slide door close position Power slide door system

Click here

Reset back door close position Power back door system

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (for Separate Console Box Type)

    Click here

  4. REMOVE CENTER NO. 2 INSTRUMENT CLUSTER FINISH PANEL (for Separate Console Box Type)

    Tech Tips

    Use the same procedure as for the center No. 1 instrument cluster finish panel. (for Separate Console Box Type)

  5. REMOVE NO. 2 BOX BOTTOM MAT (for Integrated Console Box Type)

    Click here

  6. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (for Integrated Console Box Type)

    Click here

  7. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for Integrated Console Box Type)

    Tech Tips

    Use the same procedure as for the instrument panel finish panel end LH. (for Integrated Console Box Type)

  8. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL

    Click here

  9. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  10. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

    Tech Tips

    Use the same procedure as for the No. 3 instrument panel register assembly.

  11. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET


    1. B006N3HC01
      B006N8A Remove in this Direction

      Remove the 4 bolts.

    2. Disengage the claws to pull the navigation receiver assembly with bracket as shown in the illustration.

    3. Disconnect the connectors to remove the navigation receiver assembly with bracket.

  12. REMOVE NO. 1 RADIO BRACKET


    1. B006MK3

      Remove the 4 screws and No. 1 radio bracket.

  13. REMOVE NO. 2 RADIO BRACKET


    1. B006LN1

      Remove the 4 screws.

    2. Disengage the clamp to remove the No. 2 radio bracket.

  14. REMOVE NAVIGATION RECEIVER ASSEMBLY