NAVIGATION SYSTEM(for Navigation Receiver Type) Navigation Voice Circuit

DESCRIPTION

This circuit is used when the voice switch of the steering pad switch assembly is pushed.

Using this circuit, the navigation receiver assembly sends signals to the stereo component amplifier assembly.

WIRING DIAGRAM

B006QBGE01

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)


    1. Disconnect the F2 navigation receiver assembly connector.

    2. Disconnect the F7 stereo component amplifier assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F7-15 (II1+) - F2-2 (RL+) Always Below 1 Ω
      F7-14 (II1-) - F2-6 (RL-) Always Below 1 Ω
      F7-18 (SLD1) - Body ground Always 10 kΩ or higher
      F7-15 (II1+) or F2-2 (RL+) - Body ground Always 10 kΩ or higher
      F7-14 (II1-) or F2-6 (RL-) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR