NAVIGATION SYSTEM(for Radio and Display Type) Radio Receiver Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the radio and display receiver assembly.

WIRING DIAGRAM

B006LOJE02
*a from Engine Stop and Start ECU
*b from IG1 NO. 1 Relay
*c ECU-IG NO. 3
*d Radio and Display Receiver Assembly

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE)


    1. B006RK2C03
      *a

      Front view of wire harness connector

      (to Radio and Display Receiver Assembly)

      Disconnect the F37 and F39 radio and display receiver assembly connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F37-7 (GND1) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      F37-4 (+B1) - F37-7 (GND1) Always 11 to 14 V
      F37-3 (ACC1) - F37-7 (GND1) Engine switch on (ACC) 11 to 14 V
      F39-1 (IG) - F37-7 (GND1) Engine switch on (IG) 11 to 14 V
      Result
      Result Proceed to
      OK A
      NG (except +B1 and ACC1 circuit) B
      NG (for +B1 and ACC1 circuit) C

    A

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    B

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    C

    GO TO STOP AND START SYSTEM Click here