NOISE FILTER INSTALLATION

PROCEDURE


  1. INSTALL RADIO SETTING CONDENSER


    1. B006QLE

      Engage the claw to install a new terminal cover to the wire harness.

      Note


      • Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.

      • Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

      • Do not use excessive force when inserting the wire harness into the terminal cover.

      • If the terminal cover has been deformed during installation, replace the terminal and terminal cover with new ones.

    2. B006QLG

      Engage the claws to install the 2 new terminal covers with wire harness to a new condenser.

      Note


      • Do not use excessive force when inserting the terminal covers into the condenser.

      • If a terminal cover has been deformed during installation, replace the terminal, terminal covers and condenser with new ones.

    3. B006NJS

      Insert the cover as shown in the illustration and engage the claw.

    4. B006MY5

      Engage the clamp to temporarily install the new radio setting condenser with wire harness.

    5. Install the new radio setting condenser with the bolt.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here