AMPLIFIER ANTENNA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the amplifier antenna removal/installation are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative Functions when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system (for 2AR-FE)	Click here
		Stop and start system (for 2GR-FKS)	Click here
	Memorize steering angle neutral point	Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here

PROCEDURE

REMOVE REAR NO. 2 SEAT ASSEMBLY RH

Click here
REMOVE REAR NO. 3 FLOOR BOARD ASSEMBLY

Click here
REMOVE UTILITY BOX SUB-ASSEMBLY

Click here
REMOVE REAR NO. 1 FLOOR BOARD ASSEMBLY

Click here
REMOVE REAR NO. 2 FLOOR BOARD ASSEMBLY

Click here
REMOVE REAR BACK DOOR SCUFF PLATE

Click here
REMOVE REAR DOOR SCUFF PLATE RH

Click here
REMOVE REAR UPPER NO. 1 FLOOR BOARD PLATE

Click here
REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

Click here
REMOVE ROPE HOOK ASSEMBLY

Click here
REMOVE DECK SIDE GARNISH RH

Click here
REMOVE REAR QUARTER TRIM PANEL ASSEMBLY RH

Click here
REMOVE INNER UPPER ROOF SIDE GARNISH RH

Click here
REMOVE NO. 1 COOLER AIR DUCT

Click here
REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY
1. Disconnect the 2 connectors.
2. Remove the bolt.
3. Disengage the hooks to remove the No. 1 amplifier antenna assembly.