RADIO ANTENNA CORD REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the radio antenna removal/installation are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (for 2AR-FE)

Click here

Stop and start system (for 2GR-FKS)

Click here

Memorize steering angle neutral point Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Initialize servo motor Air conditioning system

Click here

Reset slide door close position Power slide door system

Click here

Reset back door close position Power back door system

Click here

PROCEDURE


  1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  2. REMOVE CENTER DEFROSTER NOZZLE ASSEMBLY

    Click here

  3. REMOVE ANTENNA CORD SUB-ASSEMBLY (w/o Navigation System)


    1. B006NA0

      Disengage the hooks to separate the instrument cushion.

    2. Disengage the clamps to remove the antenna cord sub-assembly.

      B006NLV

  4. REMOVE ANTENNA CORD SUB-ASSEMBLY (w/ Navigation System)


    1. B006NFJ

      Disengage the hooks to separate the instrument cushion.

    2. B006QDK

      Disengage the claws to separate the connector.

    3. Disengage the clamps to remove the antenna cord sub-assembly.

      B006NSY

  5. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  6. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/o Navigation System)


    1. Remove the 9 adhesive tapes.

      B006LTY

    2. Disengage the clamps and guides to disconnect the washer hose assembly.

      B006OJVC01
      *a Clamp *b Guide

    3. Disengage the clamps and guides to disconnect the No. 2 antenna cord sub-assembly.

      B006MMPC01
      *a Clamp *b Guide

  7. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Navigation System)


    1. Remove the 16 adhesive tapes.

      B006Q3E

    2. Disengage the clamps and guides to disconnect the washer hose assembly.

      B006QCCC02
      *a Clamp *b Guide

    3. Disengage the clamps and guides to disconnect the No. 2 antenna cord sub-assembly.

      B006OWVC02
      *a Clamp *b Guide