RADIO ANTENNA CORD REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the radio antenna removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Correct the steering angle neutral point	Panoramic view monitor system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here

PROCEDURE

REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here
REMOVE CENTER DEFROSTER NOZZLE ASSEMBLY

Click here
REMOVE ANTENNA CORD SUB-ASSEMBLY (w/o Navigation System)
1. Disengage the hooks to separate the instrument cushion.
2. Disengage the clamps to remove the antenna cord sub-assembly.
REMOVE ANTENNA CORD SUB-ASSEMBLY (w/ Navigation System)
1. Disengage the hooks to separate the instrument cushion.
2. Disengage the claws to separate the connector.
3. Disengage the clamps to remove the antenna cord sub-assembly.
REMOVE ROOF HEADLINING ASSEMBLY

Click here
REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/o Navigation System)
1. Remove the 9 adhesive tapes.
2. Disengage the clamps and guides to disconnect the washer hose assembly.
  
  *a Clamp *b Guide
3. Disengage the clamps and guides to disconnect the No. 2 antenna cord sub-assembly.
  
  *a Clamp *b Guide
REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Navigation System)
1. Remove the 16 adhesive tapes.
2. Disengage the clamps and guides to disconnect the washer hose assembly.
  
  *a Clamp *b Guide
3. Disengage the clamps and guides to disconnect the No. 2 antenna cord sub-assembly.
  
  *a Clamp *b Guide